MiLAN MIL-RCM16A Specifiche Scaricare il pdf (Pagina 24)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

LIFTING CYLINDER REPLACEMENT

REPLACING PARTS

FIG. 24-1

Use ﬂ oor jack and jack stands to support platform while performing this

procedure.

WARNING

FIG. 24-2

1. Raise the open platform about 20” above the

ground. Then, place jack stands under the platform

(FIG. 24-1) for support. Measure and record the

distance between the centers of upper and lower

cylinder pins. Keep measurement for reference

when installing new cylinder.

2. Remove cover from the top of the column

(FIG. 24-1). Put empty 3 gallon container

under column for hydraulic ﬂ uid.

3. Loosen and disengage nut #1 (FIG. 24-

2) from elbow on top of cylinder. Remove

elbow from cylinder (FIG. 24-2). Keep

elbow to reinstall on new cylinder. Loosen

and disengage nut #2 from bottom of ﬂ ow

control valve.

NUT #2

“D”

VALVE

NUT #1

ELBOW

FLOW CONTROL

VALVE

Keep dirt, water and other contaminants from entering the hydraulic system.

Before opening the hydraulic ﬂ uid reservoir ﬁ ller cap, drain plug and hydraulic

lines, clean up contaminants that can get in the openings. Also, protect the

openings from accidental contamination.

CAUTION

NOTE: Refer to Operation Manual for

instructions to operate Liftgate.

COLUMN

COVERS

JACK STAND

(2 PLACES)

MEASURE

DISTANCE

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 85 86

Commenti su questo manuale

Nessun commento

MiLAN MIL-RCM16A Specifiche Pagina 24

Commenti su questo manuale

Prodotti e manuali riguardandi no MiLAN MIL-RCM16A